Robots don’t die from taking too much damage; they just keep plugging along... circuit boards and wires hanging out... sparks flying. However, when your robot falls off the board or into a pit, you must Reboot your robot. To Reboot your robot, immediately take the following steps:

1. Remove your robot from the board and place it onto your player mat. Your robot will return during the next round.

2. Whether you resolved your card for the current register or not, your programming is canceled for the rest of the round, and you may not complete any remaining registers. Immediately discard all programming cards in your remaining registers (both face up and face down), as well as all cards in your hand (including SPAM). You must wait until the next round to program your robot.

a. SPAM cards in your registers are discarded to your discard pile.

b. Haywire cards in your registers are discarded to the damage discard pile.

3. Draw 2 damage cards (1 at a time as usual).

a. If you draw SPAM, place it into your discard pile.

b. If you draw Haywire, place it face down in the current register’s slot (the one in which you fell into a pit or off the board). If you draw a second Haywire card, place it face up into the damage discard pile. All of your upgrades remain in place, even the ones you have not yet installed.