Potion Explosion

Assembling the Dispenser

menu

A ONE-TIME DO-IT-YOURSELF EXPERIENCE

(Assemblatio dispenserium ikeae)

NOTE: The following only applies to versions of the game where the Dispenser is assembled from cardboard elements.

Carefully remove the Dispenser parts from the punchboards. Then, assemble the Dispenser as shown in the diagrams below.

Placeholder

This fine-tuned procedure is the fruit of centuries of careful craft and scrupulous planning by my predecessors... and this very Professor of yours! I humbly pride myself on those nice arc-shaped marble gates. Aren’t they beautiful?

STEP 1

Placeholder

STEP 2

The frontmost insert cuts of the two depicted pieces will be empty at the end of this step. They will be used at a later point in the assembling process.

Placeholder

STEP 3

When you bend the slide pieces, make sure to bend them very well. If you don’t, the marbles may run out of the slide tracks during the game. You can then give them the correct angle and insert them into the back wall.

Placeholder
Placeholder
Placeholder

I’d point out that the bottom side of the slide is the one painted in black, and that the top side is the one with the wood texture, but it would be an insult to your intelligence, wouldn’t it?

STEP 4

Make sure to insert the inner tabs of the front wall into the two insert cuts left free during step 2.

Placeholder

STEP 5

Placeholder
Placeholder

At the cost of being offensive towards the least differently-smart among you, again: the roof has to be inserted before the arc wall, obviously. But I’m sure you already figured it out by yourselves.

Placeholder
Placeholder

Once assembled, the Dispenser will nicely fit in your Potion Explosion™ box. Thus, you won’t need to disassemble it, ever. How convenient! You’re welcome.

Next
Related Rule(s)